SPECIFICATIONS
- POWER 200 watts RMS per channel into 8 ohms. 280 watts RMS per channel into 4 ohms. Both channels driven from 20Hz to 20kHz at less than 0.2% total harmonic distortion
- FREQUENCY RESPONSE 20Hz to 20kHz ±0.2dB , -3dB at 5Hz and -3dB at 70kHz
- DISTORTION Typically <0.05% THD at rated power, 0.2% THD and IM worst case prior to clipping
- CURRENT OUTPUT 40A short duration peak per channel. Fuse protected
- SLEW RATE 50V/µs
- HUM & NOISE 90dB below rated output 20Hz to 20kHz unweighted
- INPUT IMPEDENCE 47k ohms all inputs. Phono adjustable to 47k ohms, 470 ohms, 100 ohms,47 ohms, 22 ohms
- RATED PRE OUT LEVEL 1.5V RMS into 47k ohms or higher
- PRE OUT SOURCE IMPEDENCE Typically 1.5k ohms
- PRE OUT MINIMUM RECOMMENDED LOAD 47k ohms
- LINE OUT LEVEL 190mV at 200 ohms
- GAIN Line inputs to speaker out: 40dB . Phono Input To Pre-Out: 66dB on high gain, 60dB on low gain
- POWER/CURRENT CONSUMPTION 600W , 0.4A (92W). Class AB Idle 0.14A (32W) Standby
- DIMENSIONS Height: 120mm (4 3/4”), Width: 450mm (17 3/4”), Depth: 400mm (15 3/4”), Weight: 14kg (30lb)
FEATURES
PHONO STAGE
A high quality phono stage comes fitted as standard. With two gain settings and fixed loading it allows for trouble free playback with a number of MM or MC cartridges.
LINE OUT
The Line out provides a line level output, carrying the selected source signal. The Line Out allows for the signal to go on to recording equipment, headphone amplifiers or sub-woofer speakers.
REMOTE TRIGGER INPUT AND OUTPUT
Terminals for remote trigger connection allow a processor signal to bypass the preamplifier stage or instigate the power amp to come out of standby.
GROUND LIFT SWITCH
This allows for the signal ground to be isolated from the main chassis earth. This can assist in resolving unwanted ground loops or hum due to duplicate ground paths in some systems.
WBT AND NEUTRIK CONNECTORS
High quality WBT RCA and Neutrik XLR input connectors are fitted along with WBT output speaker terminals to ensure low distortion interface between your cables and the amplifier.
AURIC WIRING
Audience AV supply the Auric OFC wire used in the input stage of the amplifier. The Auric was chosen for its high workability and natural sound.
AUDIOQUEST WIRING
AudioQuest X2 is used in the output stage of the amplifier as a high quality link to the speaker connectors.